Vehicle Emission Standards
Australia has had road vehicle emission standards for new vehicles in place since the early 1970s and these have been progressively tightened over the past 40 years. The current standards reflect Australia's commitment to harmonise with the vehicle standards developed by the United Nations wherever possible. The next steps commence in November 2013, with the first stage of the introduction of the stringent Euro 5 emission standards for light vehicles, which includes cars and light commercial vehicles.
Over the last 10 years in particular there have been improvements in a number of air quality indicators, and it is generally accepted that the increasing proportion of vehicles meeting tighter emission standards has played a major part in these air quality improvements.
The tables listed below summarise the emission limits which apply for light and heavy vehicles and their timetable for adoption in the ADRs. The ADRs are performance standards which specify the maximum levels of emissions permitted under a specified test. The ADRs do not mandate the use of particular technology, although it has been necessary for vehicle manufacturers to fit catalytic converters to light petrol and LPG vehicles in order to meet the emission limits introduced by ADR37/00 in the mid 1980's. For light duty diesel vehicles, particulate traps are necessary in most vehicles to meet the very low particle emission limits in the Euro 5 standards adopted in ADR79/03 and ADR79/04.
- Summary of Emission Standards for Light Petrol Vehicles in Australia (1972–Present)
PDF: 282 KB DOCX: 27 KB
- Emission Standards for Light Vehicles applied under ADR79/xx (2003–Present)
PDF: 365 KB DOC: 98 KB
- Emission Standards for Heavy Diesel Vehicles
PDF: 311 KB DOCX: 44 KB
The regulation of emissions from vehicles once they are on the road (in-service) is the responsibility of the state and territory governments. However, the Australian Government undertaken a number of studies to improve the understanding of emissions performance of the in-service passenger car fleet.
The National In-Service Emission Study (NISE1), published in 1996, is the most comprehensive study of emissions from cars ever undertaken in Australia. It tested over 600 vehicles manufactured between 1980 and 1993 and demonstrated that considerable exhaust emissions benefits could be obtained from regular tuning and maintenance. An update and expansion of this study, NISE 2, covering later model vehicles, was completed in March 2009.
The NISE 1 study also indicated that evaporative emissions from vehicles were, on average, well above the limits mandated in the then applicable standard, Australian Design Rule 37(ADR37). The subsequent Petrol Volatility Project (1997) examined this in more detail and concluded that reducing the volatility of commercial petrol was the most cost effective means to address this problem. States have since set limits on the volatility of summertime petrol supplies.
Vehicle Emission Reports and RISs
- Regulation Impact Statement for Review of Euro 5/6 Light Vehicle Emissions Standards PDF: 979 KB DOCX: 488 KB
- BTRE Report on Health Impacts of Transport Emissions in Australia : Economic Costs—2005
- Regulation Impact Statement for Vehicle Emission and Fuel Quality Standards Post 2006—December 2004 PDF: 928 KB
- Comparative Vehicle Emissions Study—March 2001
- Regulation Impact Statement—New Australian Design Rules for the Control of Vehicle Emissions—December 1999
- Regulation Impact Statement Main Report PDF: 1585 KB DOC: 19249 KB
- Attachment A, B & E PDF: 350 KB DOC: 481 KB—Comparison of UN ECE Standards with Current ADRs; Description of New Standards Options; and Summary of Public Comment
- Attachment C PDF: 181 KB DOC: 2331 KB—Draft Final Report—Emissions and Cost Effectiveness of the Adoption of Euro 3 Emission Standards
- Attachment D PDF: 471 KB DOC: 4481 KB—Preliminary Economic Analysis of Adopting New Vehicle Emission Standards
- Motor Vehicle Pollution in Australia
Some files available from this webpage may not be suitable for users of assistive technology on all devices. If you experience difficulties and require assistance, please contact us using the feedback page. Please include which device and assistive technology you are using.